hallo,
de spullen van voti zijn binnen.
ik heb de wasp gesoldeerd en een schakeling gemaakt op mn breadboard.
aleen als ik een programma in de pic wil schieten geeft hij een error:
code:
001 read configuration from
002 [C:\Users\kees van der heuvel/.xwisp]
003 using serial port [com3]
004 target PIC chip will be autodetected
OK
005 LOAD C:/PICprog/NR1.HEX
OK
006 GO
hardware: Wisp648 1.29 (fast)
target: 16f628a, device code 1060 revision bits 08
An exception ocurred which was not explicitly handled by the XWisp application. The traceback below might give some information about the exception.
Traceback (most recent call last):
File "xwisp.py", line 6226, in Interpret
File "xwisp.py", line 6204, in Execute
File "<string>", line 1, in <module>
File "xwisp.py", line 5449, in CMD_GO
File "xwisp.py", line 4940, in Write_Verify
File "xwisp.py", line 4841, in Write
File "xwisp.py", line 4667, in Put
File "xwisp.py", line 1095, in Send_Expect
WBus_Protocol_Error: send='2803w' received='2802V'
ERROR
en het ledje op de wasp gaat branden.
wat doe ik fout?