electrocompaniet eci-2 afstellen

Zo te zien staan een paar van die blauwe elco's ook een beetje bol, of komt dat door de foto ?

It's the rule that you live by and die for It's the one thing you can't deny Even though you don't know what the price is. It is justified.

Overigens, is het nodig om de rustspanning opnieuw af te stellen?

[Bericht gewijzigd door DJohnny op donderdag 30 september 2010 22:11:17 (13%)

Als je ampje piept en kraakt, is DJohnny die hem maakt... Kom alleen niet om garantie, want dan is DJohnny met vakantie!

De elco's zijn oke ,komt door de foto roland

Ik heb antwoord gekregen van electrocompaniet,
rustspanning meten over TP 13-TP9 voor het linker kanaal
TP 13-TP10 voor het rechter kanaal
Instellen op 13mV als de versterker koud is.
Speelt prachtig nu
Stond dus te hoog(16 mV) wat niet beter klinkt zoals zovelen zeggen...
Bedankt voor jullie raad en tot een volgend topic!

I come back to this post as i found exactly this amplifier and it is now in Italy.
Sylvainj I would like to know if possible which transistors have been replaced exactly.

Thank you in advance.

M.

Op 30 september 2010 17:50:26 schreef sylvainj:
Dus,de relais zijn vervangen en probleem opgelost.na wat meetwerk ontdekt dat er 2 transistoren stuk waren.

Nu had ik graag de laatste stap gedaan,de ruststroom regelen.
maar waar vind ik mijn emitter-weerstanden?[afbeelding]

Semtexx

Golden Member

Last reply of this user on this entire forum was 2011. Doubt you'll get an answer....

It's a shame.
I would like to check and restore everything to its original state but I can't find a schematic anywhere.
Have a nice day.

M.

Op 14 augustus 2021 13:13:05 schreef Semtexx:
Last reply of this user on this entire forum was 2011. Doubt you'll get an answer....