Philips Multimeter PM 2513 Calibration Instructions

Dear All,

I have a Philips Multimeter PM 2513 in working condition. But clearly needing a full calibration. However on the service manual widely availble on the the net, there is only the complete schematic diagram. I can’t find any information about the calibration instructions/ procedure and with all the adjustments potentiometers not identified is very difficult.
By any chance you might have the calibration instructions identifying the potentiometers location or have had this experience previously? Thanks a lot in advance. Warmest regards. Paulo

What you probably have is the User Manual and not the Service Manual.
In the SM the calibration procedure is described, but I think this document is not available on the web...

Do you know how can i get it? Thanks in advance for the help. Paulo

I could not find it either.
There were more people asking for it and some said it is not that difficult to adjust the meter.
I don't have any experience with this one.

Hello Pmoniz,

I have the service manual for you in PDF but it is too big to attach!
If you send me an email I can reply to your email.

Greeting,
Henk.

Thanks! My e-mail is moniz.p@hotmail.com

Hello Pmoniz,

It is on the way, schematics are included, but I can't find any calibration so quickly!
Maybe I still have a paper manual, but that takes too much searching time.

Greeting,
Henk.

Probably also the Directions of Use (= User Manual).

The "servicemanual" has little technical information: it's a user manual with a schematic attached... ;)

Exactly has a very detailed schematica diagram. But no information about the calibration or even the location on the PCBoard of the adjusting potentiometers….?